In order that
we can manufacture your parts as quick as possible, we have all required electrical
steel grades on stock, manufactured according to DIN EN 10106/10107 (non-grain-oriented
and grain-oriented).| Electrical steel meets the following tolerances | |
 |
+/- 8 % of the nominal value of the thickness at 0,35 mm and 0,5 mm |
|
+/- 6 % of the nominal value of the thickness at 0,65 mm and 1,0 mm |
|
However, these tolerance ranges are not normally fully explited |
As a rule, stack height tolerances are determined by the thickness of the sheet (+/- 1 the thickness of one sheet). In order to maintain tighter tolerance ranges, these stacks can be finished at a later stage.
Of course, we will also process electrical steels provided by the customer (e.g. Vacoflux, Vacoperm etc.).
